Process
Sometimes you need to scrape the wax off
Using a jointer, (carefully! she did take the top of my finger) mill to get 4 straight sides
Then cut strips on the table saw
The hard part…. what pattern?
This one…
Glue
Clamp and let sit overnight
Scrape off excess glue
Get ready to sand
Sand, sand, sand some more
Ready to bevel edges
Edges beveled
Sand again
Wet board so the grain comes to the surface—this is so your board doesn’t feel rough
Then…. sand again
Use mineral oil and spray both sides, let sit for at least 30 min
Do it again…
Then wax! and then wait
Buff…
Photoshoot time
